> From: Stefano Babic <sba...@denx.de> > > > Hi Diego, > > On 08/08/2016 18:12, Diego Dorta wrote: > > Hi Stefano, >> > > I downloaded the patch about Falcon Mode from: >> > > https://www.amazon.com/clouddrive/share/hVlzRXoJv1Jq4DJdgDcVnfmOWjARqR06eCfheWjRcSh/folder/KZakgsCMThWy3I43j2-afQ > > > > Then, as the README file says I did a checkout on commit > > 587c3f8ebe356b558f1876414885c1b4a31294ab and applied the patch. > > > > $ git am 0001-wandboard-changes-for-EW-2016-demo.patch > > > > I compiled without errors and then I've tried to upload to the SD card, by > > doing: > > > > $ sudo dd if=SPL of=/dev/sdb bs=1k seek=1; sync > > > > $ sudo dd if=u-boot.img of=/dev/sdb bs=1k seek=69; sync > > > > But, everytime I try to turn on the board I got this error: > > > > U-Boot 2016.01-rc4-26067-g0ff7f76 (Aug 08 2016 - 09:41:44 -0300) > > > > CPU: Freescale i.MX6Q rev1.2 at 792 MHz > > Reset cause: POR > > initcall sequence 178290cc failed at call 178038bd (err=394279101) > > ### ERROR ### Please RESET the board ### > > > > I'm using wanboard quad rev: B1. > > > > Does anybody know how to solve this? > > It was quite a while ago, but the patch sets Falcon mode, and it tries > to boot the kernel. Kernel is not in filesystem, but stored at a fixed > address on the SD card (0x1000). The error you reported seems when > U-Boot is starting - by pressing 'c' or if no kernel is stored.
Hi Stefano, When I use your falcon mode pre-built image everything works fine, but when I try to replace to use the binaries I've compiled, the normal mode (pressing C) doesn't work and shows this error: U-Boot 2016.01-rc4-26067-g04df0e7-dirty (Aug 12 2016 - 10:31:08 -0300) CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR initcall sequence 178290d4 failed at call 178038bd (err=394279101) ### ERROR ### Please RESET the board ### I use the following commands to copy the binaries: $ sudo dd if=SPL of=/dev/sdb bs=1K seek=1 oflag=sync status=none && sync $ sudo dd if=u-boot.img of=/dev/sdb bs=1K seek=69 oflag=sync status=none && sync How can I understand this error message? Does anyone know how to fix it? Regards, Diego Dorta _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
