Thanks Tom
> On Jul 21, 2016, at 12:39 PM, Tom Rini <tr...@konsulko.com> wrote: > >> On Wed, Jul 20, 2016 at 11:59:32PM +0200, Vikas MANOCHA wrote: >> Hi Tom, >> >>> -----Original Message----- >>> From: U-Boot [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Tom Rini >>> Sent: Saturday, July 16, 2016 6:51 AM >>> To: tnishinaga....@gmail.com >>> Cc: u-boot@lists.denx.de; gre...@linuxfoundation.org >>> Subject: Re: [U-Boot] [U-Boot, 3/3] stm32: Change USART port to USART6 for >>> stm32f746 discovery board >>> >>>> On Fri, Jul 08, 2016 at 01:02:26AM +0900, tnishinaga....@gmail.com wrote: >>>> >>>> From: Toshifumi NISHINAGA <tnishinaga....@gmail.com> >>>> >>>> This change is to remove a halt at about 200KiB while sending a >>>> large(1MiB) binary to a micro controller using USART1. >>>> USART1 is connected to a PC via an on-board ST-Link debugger that also >>>> functions as a USB-Serial converter. >>>> However, it seems to loss some data occasionally. >>>> So I changed the serial port to USART6 and connected it to the PC >>>> using an FTDI USB-Serial cable, therefore the transmission was >>>> successfully completed. >>>> >>>> Signed-off-by: Toshifumi NISHINAGA <tnishinaga....@gmail.com> >>> >>> Applied to u-boot/master, thanks! >> >> There is no serial/usb connector on discovery board to use USART6 signals. >> With this patch, it is not possible to get discovery console without >> additional circuit. Please revert this patch. >> Also I did a quick check on transferring 2.6MB binary using usart1 without >> any issue. > > Done, sorry about that. > > -- > Tom > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
