A couple of commits have modified the am33xx/am437x ddr2/ddr3
initialization path to fix certain issues, but have had the side effect
of causing L3 noc errors during initialization. The two commits are:
69b918 "am33xx,ddr3: fix ddr3 sdram configuration"
fc46ba "arm: am437x: Enable hardware leveling for EMIF"
The EMIF_REG_INITREF_DIS_MASK bit still needs to be set for all
platforms. This delays initialization and refresh until a later stage.
The 500us timer can be programmed for platforms that require it
and for platforms that don't require it. It is currently hardcoded
for 400MHz systems. For systems with a higher memory frequency
this needs to be a larger value, and for systems with a lower
memory frequency this can be a lower value. This can be
considered a separate issue and corrected in a later commit.
Signed-off-by: Russ Dill <russ.d...@ti.com>
---
arch/arm/cpu/armv7/am33xx/ddr.c | 19 +++++++------------
1 file changed, 7 insertions(+), 12 deletions(-)
diff --git a/arch/arm/cpu/armv7/am33xx/ddr.c b/arch/arm/cpu/armv7/am33xx/ddr.c
index ef1fc4d..6acf30c 100644
--- a/arch/arm/cpu/armv7/am33xx/ddr.c
+++ b/arch/arm/cpu/armv7/am33xx/ddr.c
@@ -292,19 +292,14 @@ static void ext_phy_settings_hwlvl(const struct emif_regs
*regs, int nr)
void config_ddr_phy(const struct emif_regs *regs, int nr)
{
/*
- * Disable initialization and refreshes for now until we
- * finish programming EMIF regs.
- * Also set time between rising edge of DDR_RESET to rising
- * edge of DDR_CKE to > 500us per memory spec.
+ * Disable initialization and refreshes for now until we finish
+ * programming EMIF regs and set time between rising edge of
+ * DDR_RESET to rising edge of DDR_CKE to > 500us per memory spec.
+ * We currently hardcode a value based on a max expected frequency
+ * of 400MHz.
*/
-#ifndef CONFIG_AM43XX
- setbits_le32(&emif_reg[nr]->emif_sdram_ref_ctrl,
- EMIF_REG_INITREF_DIS_MASK);
-#endif
- if (regs->zq_config)
- /* Set time between rising edge of DDR_RESET to rising
- * edge of DDR_CKE to > 500us per memory spec. */
- writel(0x00003100, &emif_reg[nr]->emif_sdram_ref_ctrl);
+ writel(EMIF_REG_INITREF_DIS_MASK | 0x3100,
+ &emif_reg[nr]->emif_sdram_ref_ctrl);
writel(regs->emif_ddr_phy_ctlr_1,
&emif_reg[nr]->emif_ddr_phy_ctrl_1);
--
2.8.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
