Hi Albin, now I tried your rewritten mmc driver.
>- Use the updated driver that I rewrote, as seen here: > http://lists.denx.de/pipermail/u-boot/2009-August/059456.html > I have tested this code on my sam9g20/sam9260 boards with a wide range of sd > and mmc cards and it seems to work well. If you test this, I would really > appreciate if you sent an answer to the patch, saying that you tested this. > If you have some extra time, you can try both and try to see if there are > regressions in the new code :) But till now I don't get it working. Here my steps: Downloaded u-boot 2009.08 changed: #if defined(CONFIG_HAS_DATAFLASH) to: #if defined(CONFIG_HAS_DATAFLASH) || defined(CONFIG_ATMEL_SPI) applied Patch: http://lists.denx.de/pipermail/u-boot/2009-September/060053.html then applied Patch V3: from mail added to:include/config/at91sam9260ek.h #define CONFIG_CMD_MMC 1 #define CONFIG_MMC 1 #define CONFIG_GENERIC_MMC added: to: board/atmel/at91sam9260ek/at91sam9260ek.c at91_mci0_hw_init(0,4); // slot 0 and bus width 4 I got the compile error: at91_mci0_hw_init not found. I added: #define CONFIG_ATMEL_MCI to include/config/at91sam9260ek.h because this at91_mci0_hw_init is in a ifdef CONFIG_ATMEL_MCI block I compile okay. I flashed it. now I have no mmc init function. I have mmc list or mmcinfo,... but if I do for example mmc list I get nothing. bye Konrad _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
