Hi Simon, On Tue, Jul 12, 2016 at 03:56:57PM -0600, Simon Glass wrote: > On 8 July 2016 at 09:42, Max Filippov <jcmvb...@gmail.com> wrote: > > Introduce MDIO communication routines. Scan MDIO bus at reset to find > > attached PHYs and see if they support gigabit speeds. If they do check > > their gigabit control register: if gigabit autonegotiation is enabled > > clear it and reset the PHY. > > > > This allows using OpenCores 10/100 MAC with gigabit PHY connected to > > gigabit network. > > > > Signed-off-by: Max Filippov <jcmvb...@gmail.com> > > --- > > drivers/net/ethoc.c | 76 > > +++++++++++++++++++++++++++++++++++++++++++++++++++++ > > 1 file changed, 76 insertions(+) > > > > diff --git a/drivers/net/ethoc.c b/drivers/net/ethoc.c > > index ee7c01e..8f70c0c 100644 > > --- a/drivers/net/ethoc.c > > +++ b/drivers/net/ethoc.c > > @@ -290,6 +290,80 @@ static int ethoc_init_ring(struct eth_device *dev) > > return 0; > > } > > > > +#ifdef CONFIG_SYS_ETHOC_SETUP_PHY > > This should be in Kconfig.
Ok, will add. -- Thanks. -- Max _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
