On Fri, Jun 17, 2016 at 4:53 PM, vinoth eswaran <evinoth1...@gmail.com> wrote: > On Fri, Jun 17, 2016 at 10:10 AM, Bin Meng <bmeng...@gmail.com> wrote: >> +Simon, Jagan, >> >> On Fri, Jun 17, 2016 at 3:55 PM, vinoth eswaran <evinoth1...@gmail.com> >> wrote: >>> Hello Mr.Bin, >>> >>> In the file minnowmax_defconfig for SPI flash I am seeing many >>> configurations getting enabled, >>> >>> CONFIG_SPI_FLASH=y >>> CONFIG_SPI_FLASH_GIGADEVICE=y >>> CONFIG_SPI_FLASH_MACRONIX=y >>> CONFIG_SPI_FLASH_STMICRO=y >>> CONFIG_SPI_FLASH_WINBOND=y >>> >>> Do we need all the configurations and also I have seen a patch >>> regarding this but not included in the mainline, >>> >>> http://lists.denx.de/pipermail/u-boot/2015-November/235822.html >>> >>> For Minnowmax Turbot , can I use only the following configuration? >>> CONFIG_SPI_FLASH=y >>> CONFIG_SPI_FLASH_STMICRO=y >>> >> >> Sure. >> > > I am using SPI Hook to flash the u-boot.rom. In the SPI Hook log , I > am seeing that the flash driver is Winbond and not STMICRO, > > flashrom v0.9.8-r1888 on Linux 3.11.0-26-generic (x86_64) > flashrom is free software, get the source code at http://www.flashrom.org > > Calibrating delay loop... OK. > Found Winbond flash chip "W25Q64.V" (8192 kB, SPI) on ft2232_spi. > > Then I should enable CONFIG_SPI_FLASH_WINBOND and not > CONFIG_SPI_FLASH_STMICRO right??
No. It is a STMicro flash, not WinBond. [snip] Regards, Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
