On Fri, Jun 17, 2016 at 10:10 AM, Bin Meng <bmeng...@gmail.com> wrote: > +Simon, Jagan, > > On Fri, Jun 17, 2016 at 3:55 PM, vinoth eswaran <evinoth1...@gmail.com> wrote: >> Hello Mr.Bin, >> >> In the file minnowmax_defconfig for SPI flash I am seeing many >> configurations getting enabled, >> >> CONFIG_SPI_FLASH=y >> CONFIG_SPI_FLASH_GIGADEVICE=y >> CONFIG_SPI_FLASH_MACRONIX=y >> CONFIG_SPI_FLASH_STMICRO=y >> CONFIG_SPI_FLASH_WINBOND=y >> >> Do we need all the configurations and also I have seen a patch >> regarding this but not included in the mainline, >> >> http://lists.denx.de/pipermail/u-boot/2015-November/235822.html >> >> For Minnowmax Turbot , can I use only the following configuration? >> CONFIG_SPI_FLASH=y >> CONFIG_SPI_FLASH_STMICRO=y >> > > Sure. >
I am using SPI Hook to flash the u-boot.rom. In the SPI Hook log , I am seeing that the flash driver is Winbond and not STMICRO, flashrom v0.9.8-r1888 on Linux 3.11.0-26-generic (x86_64) flashrom is free software, get the source code at http://www.flashrom.org Calibrating delay loop... OK. Found Winbond flash chip "W25Q64.V" (8192 kB, SPI) on ft2232_spi. Then I should enable CONFIG_SPI_FLASH_WINBOND and not CONFIG_SPI_FLASH_STMICRO right?? > As for SPI flash config macro clean-up, I am inclined remove unneeded > one, but Jagan may have the new spi-nor framework that simplify these > SPI flash macros. > > Jagan, when do you plan to have the new spi-nor framework ready in mainline? > > Regards, > Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
