Hi Marek, On Mon, Apr 4, 2016 at 1:02 PM, Marek Vasut <ma...@denx.de> wrote: > > On 04/04/2016 09:59 PM, Steve Rae wrote: > > Turn on the USB OTG clocks. > > > > Signed-off-by: Steve Rae <s...@broadcom.com> > > --- > > > > drivers/usb/gadget/bcm_udc_otg_phy.c | 4 ++++ > > 1 file changed, 4 insertions(+) > > > > diff --git a/drivers/usb/gadget/bcm_udc_otg_phy.c > > b/drivers/usb/gadget/bcm_udc_otg_phy.c > > index 10b2e13..877f162 100644 > > --- a/drivers/usb/gadget/bcm_udc_otg_phy.c > > +++ b/drivers/usb/gadget/bcm_udc_otg_phy.c > > @@ -8,12 +8,16 @@ > > #include <common.h> > > #include <asm/io.h> > > #include <asm/arch/sysmap.h> > > +#include <asm/kona-common/clk.h> > > > > #include "dwc2_udc_otg_priv.h" > > #include "bcm_udc_otg.h" > > > > void otg_phy_init(struct dwc2_udc *dev) > > { > > + /* turn on the USB OTG clocks */ > > + clk_usb_otg_enable((void *)HSOTG_BASE_ADDR); > > I _think_ this driver is used on RPi too, did you compile test it there?
no, it is not - the only place this is used is: drivers/usb/gadget/Makefile:obj-$(CONFIG_USB_GADGET_BCM_UDC_OTG_PHY) += bcm_udc_otg_phy.o include/configs/bcm28155_ap.h:#define CONFIG_USB_GADGET_BCM_UDC_OTG_PHY Thanks, Steve PS. "rpi" and "rpi_2" both build successfully.... > > > > /* set Phy to driving mode */ > > wfld_clear(HSOTG_CTRL_BASE_ADDR + HSOTG_CTRL_PHY_P1CTL_OFFSET, > > HSOTG_CTRL_PHY_P1CTL_NON_DRIVING_MASK); > > > > > -- > Best regards, > Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot