On 03/09/2016 10:22 AM, Bakhvalov, Denis (Nokia - PL/Wroclaw) wrote: > Hi, > >> However there is still no ping in U-Boot. >> After power reset I did: >> >>> # bridge disable >>> # fpga load 0 <addr> <size> >>> # bridge enable >> >>> # md 0xff706000 1 >> ff706000: 00000074 <-- this means fpga is in user mode >> >>> # setenv ethaddr ... >>> # setenv ipaddr ... >>> # setenv netmask ... >>> # setenv gatewayip ... >> >> => ping 192.168.1.126 >> Speed: 100, full duplex >> Using ethernet@ff702000 device >> ping failed; host 192.168.1.126 is not alive >> >> With similar commands on previous U-Boot version I had ping. > > Also using wireshark I found that board sends correct ARP packets to PC. > PC in it's turn send valid ARP response to the board. > But for some reason ARP reply is not handled by the board. > And board doesn't send ICMP packets to the PC. > > I already checked ip addresses, they should be fine. > Also the same IP works fine for previous U-Boot version (2013). > > What could be the reason for that?
Perform usual test, disable cache (dcache off) . And please CC the usual lineup, Chin and Dinh ;-) -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
