Dear Prafulla Wadaskar, In message <73173d32e9439e4abb5151606c3e19e202e3915...@sc-vexch1.marvell.com> you wrote: > > > Hm... aren't there known issues with these compiler versions on ARM? > I don't think so, I observed same behavior with sheevaplug,
Which tool chain are you using? Do you see differnt behaviour with and without USE_PRIVATE_LIBGCC=yes ? > i.e. "nand_bbt: Can't scan flash and build the RAM-based BBT" message in nand > init > which was okay before this git pull But this is a different error message, isn;t it? > > Is this with or without USE_PRIVATE_LIBGCC=yes ? > Yes, the build might be with this defined "yes", without this build throws > error message Argh... Could you please provide a usable error report? Which exact tool chain is this? What are your exact commands to configure and build the board? What are the exact error messages? > This is openrd board, not yet mainlined, it is derived from sheevaplug, (na> > nd is similar) > Alternately you can refer sheevaplug.h since problem is on sheevaplug too. I don;t see any error messages when building, and I don't have such a board to actually run the code. > I tried removing this patch and things are normal on sheevaplug I wish you had reported such issues when the patch was posted. There has been _long_ discussion about it. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de "This is a test of the Emergency Broadcast System. If this had been an actual emergency, do you really think we'd stick around to tell you?" _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
