Dear "David Collier", In message <memo.20090812101725.100...@postmaster+dexdyne.com.cix.co.uk> you wrote: > > Dear "Dexdyne Postmaster", > > whoops - fixed that now!!!
Thanks. > > This depends on your configuration. When using an "embedded" > > environment, this will get replaced with each install. > > " this will get replaced with each install " > > sorry - I don't know how you mean that will happen.... If you flash a new U-Boot image, this will also overwrite the embedded environment with the one built into the U-Boot image. > OK - I'm working on an AVR32 - if I follow the instructions they give, it I have no idea who "they" are, nor what instructions "they" give, but if you follow their advice you should probably ask them for help, too. > replaces the u-boot code, and leaves the environment sector in flash > unchanged. > I have added a 1-byte-write to the sector to my script to corrupt it.... > but a command would be easier. As mentioned above, with an embedded environment this is not needed. > OK again - I don't seem to have scripting enabled in my u-boot - I'd like > to do that so I can use && in by boot sequence. Well, then enable it. > What would I put in a script to have the effect of forcing a load of the > new defaults??? If there's no single command, do you mean I could make up > a script full of "set" commands? A list of "setevn" commands, correct. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de When the ax entered the forest, the trees said, "The handle is one of us!" -- Turkish proverb _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot