Also add dependency on PHYLIB and MII which is required.
Clean PHYLIB dependency from the driver too.
Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---
drivers/net/Kconfig | 8 ++++++++
drivers/net/xilinx_axi_emac.c | 4 ----
2 files changed, 8 insertions(+), 4 deletions(-)
diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
index 13e0269a30b0..15422e93fb93 100644
--- a/drivers/net/Kconfig
+++ b/drivers/net/Kconfig
@@ -101,6 +101,14 @@ config PCH_GBE
This MAC is present in Intel Platform Controller Hub EG20T. It
supports 10/100/1000 Mbps operation.
+config XILINX_AXIEMAC
+ depends on DM_ETH && (MICROBLAZE || ARCH_ZYNQ || ARCH_ZYNQMP)
+ select PHYLIB
+ select MII
+ bool "Xilinx AXI Ethernet"
+ help
+ This MAC is present in Xilinx Microblaze, Zynq and ZynqMP SoCs.
+
config ZYNQ_GEM
depends on DM_ETH && (ARCH_ZYNQ || ARCH_ZYNQMP)
select PHYLIB
diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
index e8a8d9cc2744..555952ffdc83 100644
--- a/drivers/net/xilinx_axi_emac.c
+++ b/drivers/net/xilinx_axi_emac.c
@@ -17,10 +17,6 @@
DECLARE_GLOBAL_DATA_PTR;
-#if !defined(CONFIG_PHYLIB)
-# error AXI_ETHERNET requires PHYLIB
-#endif
-
/* Link setup */
#define XAE_EMMC_LINKSPEED_MASK 0xC0000000 /* Link speed */
#define XAE_EMMC_LINKSPD_10 0x00000000 /* Link Speed mask for 10 Mbit */
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
