On Mon, Nov 30, 2015 at 4:23 PM, Joe Hershberger
<joe.hershber...@gmail.com> wrote:
> On Fri, Nov 27, 2015 at 4:29 AM, Stefan Roese <s...@denx.de> wrote:
>> Update this driver to support driver model. As all MVEBU boards using
>> this driver are converted with this patch, the non-driver-model code
>> can be removed completely. This is also the reason why this patch
>> is quite big and includes a) the driver change and b) the
>> platform change. As its not git-bisect save otherwise.
>>
>> With this conversion, some parameters are now extracted from the
>> DT instread of using the config header defines. The supported
>> properties right now are:
>>
>> PHY-mode ("phy-mode") and PHY-address ("reg").
>>
>> The base addresses for the ethernet controllers can be removed from
>> the header files as well.
>>
>> Please note that this patch also removes the E1000 network driver
>> from some MVEBU config headers. This is necessary, as with DM_ETH
>> configured and the e1000 driver enabled, the PCI driver also needs
>> to support DM. But the MVEBU PCI(e) driver still needs to get
>> ported to DM. When this is done, the E1000 driver can be enabled
>> again.
>>
>> Signed-off-by: Stefan Roese <s...@denx.de>
>> Cc: Luka Perkov <luka.per...@sartura.hr>
>> Cc: Dirk Eibach <dirk.eib...@gdsys.cc>
>> Cc: Joe Hershberger <joe.hershber...@ni.com>
>> Cc: Simon Glass <s...@chromium.org>
>> ---
>> arch/arm/Kconfig | 1 +
>> arch/arm/mach-mvebu/cpu.c | 24 ---
>> arch/arm/mach-mvebu/include/mach/soc.h | 4 -
>> board/Marvell/db-mv784mp-gp/db-mv784mp-gp.c | 32 ++--
>> board/maxbcm/maxbcm.c | 20 ++-
>> drivers/net/mvneta.c | 230
>> ++++++++++++++++------------
>> include/configs/db-88f6820-gp.h | 3 -
>> include/configs/db-mv784mp-gp.h | 4 -
>> include/configs/maxbcm.h | 3 -
>> 9 files changed, 154 insertions(+), 167 deletions(-)
>>
>> diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
>> index 2e20212..0c4794b 100644
>> --- a/arch/arm/Kconfig
>> +++ b/arch/arm/Kconfig
>> @@ -117,6 +117,7 @@ config ARCH_MVEBU
>> select OF_CONTROL
>> select OF_SEPARATE
>> select DM
>> + select DM_ETH
>
> All ARM boards? Am I missing something? Seems a bit broad for the
> scope of this patch.
Nevermind. Didn't notice the scoping of "config ARCH_MVEBU".
>
>> select DM_SERIAL
>> select DM_SPI
>> select DM_SPI_FLASH
>
> Otherwise, looks good.
>
> -Joe
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
