[U-Boot] [PATCH] eth: dtsec: fix TBI ANA setting bug in dtsec_configure_serdes()

[Yuanzheng Li]

The TBI_ANA register is configurated with the wrong value 0x4001, refer
to QorIQ Data Path Acceleration Architecture (DPAA) Reference Manual.
It set the reserved areas, bit 1 and bit 11 to bit 15 in big endian,
which should be cleared. But the normal functions of the auto-negotiation,
e.g. Pause and Full Duplex, do not be set.

There is no problem in the p2041rdb board, because the ppc is connected
directly with the phy chip which support auto-negotiation by default in
SGMII interface. But the link problem will occur when it is connected with
a switch chip like BCM5389, the switch chip disable auto-negotiation by
default, and the ppc also disable auto-negotiation, then there is no link
between them.

So use the vlue TBIANA_SETTINGS to enable the ppc's auto-negotiation.

Signed-off-by: Yuanzheng Li <liyuanzhen...@163.com>
Cc: York Sun <york...@freescale.com>
---
 drivers/net/fm/eth.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/fm/eth.c b/drivers/net/fm/eth.c
index eb8e936..78c0988 100644
--- a/drivers/net/fm/eth.c
+++ b/drivers/net/fm/eth.c
@@ -81,7 +81,7 @@ qsgmii_loop:
        tsec_local_mdio_write(phyregs, in_be32(&regs->tbipa), 0, TBI_TBICON,
                        TBICON_CLK_SELECT);
        tsec_local_mdio_write(phyregs, in_be32(&regs->tbipa), 0, TBI_ANA,
-                       TBIANA_SGMII_ACK);
+                       TBIANA_SETTINGS);
        tsec_local_mdio_write(phyregs, in_be32(&regs->tbipa), 0,
                        TBI_CR, TBICR_SETTINGS);
 #endif
-- 
1.7.8

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot