When 4 chip-selects are used, vref should use range 1 and CDT uses 80 ohm,
and 2T timing is enabled.
Signed-off-by: York Sun <york...@freescale.com>
---
board/freescale/ls2085aqds/ddr.c | 16 ++++++++++++----
1 file changed, 12 insertions(+), 4 deletions(-)
diff --git a/board/freescale/ls2085aqds/ddr.c b/board/freescale/ls2085aqds/ddr.c
index 8d71ae1..d8562b1 100644
--- a/board/freescale/ls2085aqds/ddr.c
+++ b/board/freescale/ls2085aqds/ddr.c
@@ -131,10 +131,18 @@ found:
popts->zq_en = 1;
if (ddr_freq < 2350) {
- popts->ddr_cdr1 = DDR_CDR1_DHC_EN |
- DDR_CDR1_ODT(DDR_CDR_ODT_60ohm);
- popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_60ohm) |
- DDR_CDR2_VREF_RANGE_2;
+ if (pdimm[0].n_ranks == 2 && pdimm[1].n_ranks == 2) {
+ /* four chip-selects */
+ popts->ddr_cdr1 = DDR_CDR1_DHC_EN |
+ DDR_CDR1_ODT(DDR_CDR_ODT_80ohm);
+ popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_80ohm);
+ popts->twot_en = 1; /* enable 2T timing */
+ } else {
+ popts->ddr_cdr1 = DDR_CDR1_DHC_EN |
+ DDR_CDR1_ODT(DDR_CDR_ODT_60ohm);
+ popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_60ohm) |
+ DDR_CDR2_VREF_RANGE_2;
+ }
} else {
popts->ddr_cdr1 = DDR_CDR1_DHC_EN |
DDR_CDR1_ODT(DDR_CDR_ODT_100ohm);
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
