When converting between PCI bus and phys addresses, a two pass search
was introduced with preference to non-PCI_REGION_SYS_MEMORY regions.
See commit 2d43e873a29ca4959ba6a30fc7fb396d3fd0dccf.
However, since PCI_REGION_MEM is defined as 0, the if statement was
always asserted true: ((flags & PCI_REGION_MEM) == PCI_REGION_MEM)
This patch uses PCI_REGION_TYPE bit to check if the region is
PCI_REGION_MEM: ((flags & PCI_REGION_TYPE) == PCI_REGION_MEM)
Signed-off-by: Cheng Gu <chen...@marvell.com>
---
drivers/pci/pci_common.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/pci/pci_common.c b/drivers/pci/pci_common.c
index 07f1726..a64792f 100644
--- a/drivers/pci/pci_common.c
+++ b/drivers/pci/pci_common.c
@@ -231,7 +231,7 @@ phys_addr_t pci_hose_bus_to_phys(struct pci_controller
*hose,
* if PCI_REGION_MEM is set we do a two pass search with preference
* on matches that don't have PCI_REGION_SYS_MEMORY set
*/
- if ((flags & PCI_REGION_MEM) == PCI_REGION_MEM) {
+ if ((flags & PCI_REGION_TYPE) == PCI_REGION_MEM) {
ret = __pci_hose_bus_to_phys(hose, bus_addr,
flags, PCI_REGION_SYS_MEMORY, &phys_addr);
if (!ret)
@@ -298,7 +298,7 @@ pci_addr_t pci_hose_phys_to_bus(struct pci_controller *hose,
* if PCI_REGION_MEM is set we do a two pass search with preference
* on matches that don't have PCI_REGION_SYS_MEMORY set
*/
- if ((flags & PCI_REGION_MEM) == PCI_REGION_MEM) {
+ if ((flags & PCI_REGION_TYPE) == PCI_REGION_MEM) {
ret = __pci_hose_phys_to_bus(hose, phys_addr,
flags, PCI_REGION_SYS_MEMORY, &bus_addr);
if (!ret)
--
2.1.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
