Hi All,
I am working on USB part for vybrid vf-610 processor, We have two ports in the
board
when I type usb start in uboot command prompt, It returns as ENODEV for USB0
and when analyzed, It is returning from the below code in ehci-hcd_init
function(in ehci-vf.c)
if (init == USB_INIT_HOST && index == 0)
return -ENODEV;
If these two lines are commented, the usb start is working and device is
found on USB0.
Why is this check kept in the code?
Regards,
Santhosh
::DISCLAIMER::
----------------------------------------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended
for the named recipient(s) only.
E-mail transmission is not guaranteed to be secure or error-free as information
could be intercepted, corrupted,
lost, destroyed, arrive late or incomplete, or may contain viruses in
transmission. The e mail and its contents
(with or without referred errors) shall therefore not attach any liability on
the originator or HCL or its affiliates.
Views or opinions, if any, presented in this email are solely those of the
author and may not necessarily reflect the
views or opinions of HCL or its affiliates. Any form of reproduction,
dissemination, copying, disclosure, modification,
distribution and / or publication of this message without the prior written
consent of authorized representative of
HCL is strictly prohibited. If you have received this email in error please
delete it and notify the sender immediately.
Before opening any email and/or attachments, please check them for viruses and
other defects.
----------------------------------------------------------------------------------------------------------------------------------------------------
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
