On 09/23/2015 12:48 AM, Yuan Yao wrote: > I2C1 can work on ls102xa rev2.0 SD boot, so add > ID EEPROM for SD boot. > > Signed-off-by: Yuan Yao <yao.y...@freescale.com> > --- > include/configs/ls1021atwr.h | 2 -- > 1 file changed, 2 deletions(-) > > diff --git a/include/configs/ls1021atwr.h b/include/configs/ls1021atwr.h > index 7dcb719..59e704e 100644 > --- a/include/configs/ls1021atwr.h > +++ b/include/configs/ls1021atwr.h > @@ -278,7 +278,6 @@ > #define CONFIG_SYS_I2C_MXC_I2C3 /* enable I2C bus 3 */ > > /* EEPROM */ > -#ifndef CONFIG_SD_BOOT > #define CONFIG_ID_EEPROM > #define CONFIG_SYS_I2C_EEPROM_NXID > #define CONFIG_SYS_EEPROM_BUS_NUM 1 > @@ -286,7 +285,6 @@ > #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 > #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 > #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 > -#endif > > /* > * MMC >
What would happen if you run the new u-boot image on earlier SoC? Do you need to check SVR in function mac_read_from_eeprom()? York _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
