Hi Markus, On 24/09/2015 17:03, Markus Stelzhammer wrote: > Hi Stefano, > > > Today I grabbed a different Hardware with a bigger NAND chip (512 > instead of 256MB). > At this hardware, SPL is not able to jump to U-Boot. So currently I > assume that I might have some problems when flashing. >
If you are not flashing correctly, SPL does not run. It looks like that your board boots (SPL runs). > Would you be so kind to review my header file if I miss something or if > there is something completely wrong?! (I attached it) > The commands I use to flash are the following: > >> ./kobs-ng init -v -x SPL >> nandwrite --start=0x11000 --pad /dev/mtd0 u-boot.uim > (I also tried to flash u-boot.bin and u-boot.imx) > > The output I get at boot are the following, but then it stucks. > ....... >>>spl:board_init_r() > using memory 0x18300000-0x1b500000 for malloc() > spl_init() > boot device - 4 > spl: nand - using hw ecc > NAND : 0x01:0xdc erasesize=1 (>>0) erasesize = 1 ?? > writesize=-1 (>>0) > oobsize=65535 > chipsize=1095216660225 > Not support the NAND chips whose oob size is larger then 1024 bytes! > 1044479 MiB This larger NAND cannot be recognized correctly - it is not a problem by flashing. You have to investigate why this NAND (even if ONFI) is not recognized, but it is a different problem as the one you reported previously. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
