Hi,
On Thu, 2015-09-03 at 16:19 +0200, ma...@denx.de wrote:
> On Thursday, September 03, 2015 at 03:42:00 PM, Chin Liang See wrote:
> > Fix the fdt read for spi-max-frequency as it's contained
> > in the child node. Current state of code is always
> > returning default value.
> >
> > Signed-off-by: Chin Liang See <cl...@altera.com>
> > Cc: Dinh Nguyen <dingu...@opensource.altera.com>
> > Cc: Dinh Nguyen <dinh.li...@gmail.com>
> > Cc: Marek Vasut <ma...@denx.de>
> > Cc: Stefan Roese <s...@denx.de>
> > Cc: Vikas Manocha <vikas.mano...@st.com>
> > Cc: Jagannadh Teki <jt...@openedev.com>
> > Cc: Pavel Machek <pa...@denx.de>
> > ---
> > drivers/spi/cadence_qspi.c | 8 ++++----
> > 1 files changed, 4 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
> > index 300934e..a00af87 100644
> > --- a/drivers/spi/cadence_qspi.c
> > +++ b/drivers/spi/cadence_qspi.c
> > @@ -291,10 +291,6 @@ static int cadence_spi_ofdata_to_platdata(struct
> > udevice *bus) plat->regbase = (void *)data[0];
> > plat->ahbbase = (void *)data[2];
> >
> > - /* Use 500KHz as a suitable default */
> > - plat->max_hz = fdtdec_get_int(blob, node, "spi-max-frequency",
> > - 500000);
> > -
> > /* All other paramters are embedded in the child node */
> > subnode = fdt_first_subnode(blob, node);
> > if (subnode < 0) {
> > @@ -302,6 +298,10 @@ static int cadence_spi_ofdata_to_platdata(struct
> > udevice *bus) return -ENODEV;
> > }
> >
> > + /* Use 500KHz as a suitable default */
> > + plat->max_hz = fdtdec_get_int(blob, subnode, "spi-max-frequency",
> > + 500000);
>
> Use fdtdec_get_u32() or such, since the value is unsigned int (have you ever
> seen negative frequency ? ;-) ). Then check the fdtdec_get_u32() return value.
>
I git grep and no unsigned version.
But I can add unsigned casting to avoid that.
Thanks
Chin Liang
> > /* Read other parameters from DT */
> > plat->page_size = fdtdec_get_int(blob, subnode, "page-size", 256);
> > plat->block_size = fdtdec_get_int(blob, subnode, "block-size", 16);
>
> Best regards,
> Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
