There is quite a bit of assembler code that can be removed if we use the
generic global_data setup. Less arch-specific code makes it easier to add
new features and maintain the start-up code.
Drop the unneeded code and adjust the hooks in board_f.c to cope.
Signed-off-by: Simon Glass <s...@chromium.org>
---
arch/arm/lib/crt0.S | 28 ++++------------------------
1 file changed, 4 insertions(+), 24 deletions(-)
diff --git a/arch/arm/lib/crt0.S b/arch/arm/lib/crt0.S
index afd4f10..fc1252d 100644
--- a/arch/arm/lib/crt0.S
+++ b/arch/arm/lib/crt0.S
@@ -76,31 +76,11 @@ ENTRY(_main)
#else
bic sp, sp, #7 /* 8-byte alignment for ABI compliance */
#endif
- mov r2, sp
- sub sp, sp, #GD_SIZE /* allocate one GD above SP */
-#if defined(CONFIG_CPU_V7M) /* v7M forbids using SP as BIC destination */
- mov r3, sp
- bic r3, r3, #7
- mov sp, r3
-#else
- bic sp, sp, #7 /* 8-byte alignment for ABI compliance */
-#endif
- mov r9, sp /* GD is above SP */
- mov r1, sp
+ mov r0, sp
+ bl board_init_f_mem
+ mov sp, r0
+
mov r0, #0
-clr_gd:
- cmp r1, r2 /* while not at end of GD */
-#if defined(CONFIG_CPU_V7M)
- itt lo
-#endif
- strlo r0, [r1] /* clear 32-bit GD word */
- addlo r1, r1, #4 /* move to next */
- blo clr_gd
-#if defined(CONFIG_SYS_MALLOC_F_LEN)
- sub sp, sp, #CONFIG_SYS_MALLOC_F_LEN
- str sp, [r9, #GD_MALLOC_BASE]
-#endif
- /* mov r0, #0 not needed due to above code */
bl board_init_f
#if ! defined(CONFIG_SPL_BUILD)
--
2.5.0.276.gf5e568e
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
