The device tree provides information about which regulators should be
on at boot, or always on. Use this to set them up automatically.

Signed-off-by: Simon Glass <s...@chromium.org>
---

Changes in v3: None
Changes in v2: None

 drivers/power/regulator/regulator-uclass.c | 22 ++++++++++++++++++++++
 include/power/regulator.h                  | 11 +++++++++++
 2 files changed, 33 insertions(+)

diff --git a/drivers/power/regulator/regulator-uclass.c 
b/drivers/power/regulator/regulator-uclass.c
index 687d3b1..a2d0b9f 100644
--- a/drivers/power/regulator/regulator-uclass.c
+++ b/drivers/power/regulator/regulator-uclass.c
@@ -306,6 +306,28 @@ static int regulator_pre_probe(struct udevice *dev)
        return 0;
 }
 
+int regulators_enable_boot_on(bool verbose)
+{
+       struct udevice *dev;
+       struct uclass *uc;
+       int ret;
+
+       ret = uclass_get(UCLASS_REGULATOR, &uc);
+       if (ret)
+               return ret;
+       for (uclass_first_device(UCLASS_REGULATOR, &dev);
+            dev && !ret;
+            uclass_next_device(&dev)) {
+               ret = regulator_autoset(dev);
+               if (ret == -EMEDIUMTYPE)
+                       continue;
+               if (verbose)
+                       regulator_show(dev, ret);
+       }
+
+       return ret;
+}
+
 UCLASS_DRIVER(regulator) = {
        .id             = UCLASS_REGULATOR,
        .name           = "regulator",
diff --git a/include/power/regulator.h b/include/power/regulator.h
index 86e9c3b..0bdb496 100644
--- a/include/power/regulator.h
+++ b/include/power/regulator.h
@@ -316,6 +316,17 @@ int regulator_get_mode(struct udevice *dev);
 int regulator_set_mode(struct udevice *dev, int mode_id);
 
 /**
+ * regulators_enable_boot_on() - enable regulators needed for boot
+ *
+ * This enables all regulators which are marked to be on at boot time. This
+ * only works for regulators which don't have a range for voltage/current,
+ * since in that case it is not possible to know which value to use.
+ *
+ * This effectively caslls regulator_autoset() for every regulator.
+ */
+int regulators_enable_boot_on(bool verbose);
+
+/**
  * regulator_autoset: setup the the voltage/current on a regulator
  *
  * The setup depends on constraints found in device's uclass's platform data
-- 
2.4.3.573.g4eafbef

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to