On Monday 13 July 2009 16:28:33 Eibach, Dirk wrote: > > > I narrowed it down to board_early_init_r() where > > > > remove_tlb() is done. > > > > Before or after the remove_tlb()? > > It is in remove_tlb().
OK. > > > When I do a 'res halt' 'res run' sequence with the BDI the > > > > board comes > > > > > up fine. > > > > > > Any ideas? > > > > No, sorry. I haven't done much work on Canyonlands lately. Is > > this problem new? When did it first appear on your system? > > u-boot-2009.01 works fine. After upgrading to current git I didn't > notice the problem at once because it appears only after powercycling > the board. I suggest you halt (while (1) ;) you system right before the remove_tlb() call and check the TLB setup via the BDI. This should give you an idea what's wrong here. Otherwise "git bisect" is your fried... Thanks. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
