Hi Przemyslaw, On 23 April 2015 at 06:31, Przemyslaw Marczak <p.marc...@samsung.com> wrote: > Hello Simon, > > On 04/20/2015 08:07 PM, Przemyslaw Marczak wrote: >> >> This driver implements regulator operations for fixed Voltage/Current >> value regulators. beside the standard regulator constraints, which are >> put into the uclass platform data, a typical fixed regulator node provides >> few additional properties like: >> - gpio >> - gpio-open-drain >> - enable-active-high >> - startup-delay-us >> The only 'gpio' is used by this driver and is kept in structure of type >> 'fixed_regulator_platdata', as a device platform data (dev->platdata). >> >> The driver implements: >> - get_value >> - get_current >> - get_enable >> - set_enable >> >> The regulator calls and commands can be used for fixed-regulator devices, >> and the proper error will be returned for prohibited. >> >> Signed-off-by: Przemyslaw Marczak <p.marc...@samsung.com> >> > > I missed the separation (---) here and I see that you add ACK below the > changes. > Could you remove them from the tree?
OK, done. You could try patman which handles this automatically. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot