Hello Simon,
On 04/20/2015 08:07 PM, Przemyslaw Marczak wrote:
This driver implements regulator operations for fixed Voltage/Current
value regulators. beside the standard regulator constraints, which are
put into the uclass platform data, a typical fixed regulator node provides
few additional properties like:
- gpio
- gpio-open-drain
- enable-active-high
- startup-delay-us
The only 'gpio' is used by this driver and is kept in structure of type
'fixed_regulator_platdata', as a device platform data (dev->platdata).
The driver implements:
- get_value
- get_current
- get_enable
- set_enable
The regulator calls and commands can be used for fixed-regulator devices,
and the proper error will be returned for prohibited.
Signed-off-by: Przemyslaw Marczak <p.marc...@samsung.com>
I missed the separation (---) here and I see that you add ACK below the
changes.
Could you remove them from the tree?
Changes v3:
- new file
- Kconfig add fixed-regulator entry
Changes V4:
- move DM_REGULATOR_FIXED Kconfig entry from: drivers/power/Kconfig to
drivers/power/regulator/Kconfig
- regulator/fixed.c: adjust to use of uclass platdata and device platdata
- regulator/fixed.c: includes cleanup
- regulator/fixed.c: fix gpio request
- add binding info
---
doc/device-tree-bindings/regulator/fixed.txt | 38 ++++++++
drivers/power/regulator/Kconfig | 8 ++
drivers/power/regulator/Makefile | 1 +
drivers/power/regulator/fixed.c | 126 +++++++++++++++++++++++++++
4 files changed, 173 insertions(+)
create mode 100644 doc/device-tree-bindings/regulator/fixed.txt
create mode 100644 drivers/power/regulator/fixed.c
Best regards,
--
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
p.marc...@samsung.com
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
