Hello, This is the third version of the patchset which adds support for the Toradex Colibri Vybrid VF50 and VF61 modules. Boot up has been tested using the serial loader over UART. Compile tested for vf610twr_defconfig and vf610twr_nand_defconfig as well.
First patch in the series refactors the DDR related code for use by both the tower board and colibri modules. It also introduces a DDR3 based JEDEC timing structure. Second third and fourth patch in this series are improvement patches related to RTC, SoC/CPU detection and caches. Fifth patch introduces USB support for Vybrid modules. Much of the code is similar to the ehci-mx6 driver. Both host and client modes are working and DFU has also been tested with client. Currently, we restrict the ports to be in one of host and client mode. Sixth patch adds the actual support for the Colibri modules. Comments and feedback are most welcome. Thanks for the feedback till now. The patchset is based and tested on the latest master branch as of this writing. Discussion on the version 2 of the patchset can be found at the below link: https://www.mail-archive.com/u-boot@lists.denx.de/msg168727.html Discussion on the version 1 of the patchset can be found at the below link: https://www.mail-archive.com/u-boot@lists.denx.de/msg168136.html Changes since v2: - Rework the USB driver to use register + offset method in light of discussion which Fabio Estevam pointed out instead of the regular struct{} method which v2 used. The discussion is at the below link: https://www.marc.info/?l=u-boot&m=142609602127309&w=2 - Reorder the patchset, putting the USB support in the end and add an additional patch for adding USB support to Colibri modules. By chance if more discussions happen on the USB support, this allows picking up of atleast the first patches on which no issues have been reported so far. - The register definitions have been moved under arch/arm/include/asm/ imx-common in the regs-usbphy.h file. This was agreed on after discussion with Marek and some input from Peter Chen. Since it is not clear if SoC's other than Freescale's use the Sigmatel Phy's which seem to be use in iMX/VF/MXS, put the USH PHY register definitions in imx-common rather than include/usb in a chipidea specific file. - Remove setting of a PLL divisor select which was added for USB but is actually not required considering default value. It also seems to break USB after my latest rebase. The file in question concerning the change is colibri_vf.c. PLL divisor selects the PLL Multiplication factor which by default is 0, setting Fout = Fref * 20 giving 480MHz. The earlier patch set this to 1 giving Fout = Fref * 22 where Fref = 24MHz. - Rebased on the latest master branch. Changes since v1: - Rework the USB driver to use register offsets using the regular struct {} method - Some cleanups and fixes in the sixth patch for the colibri_vf.h file which takes care of environment variables in uboot - Purge some useless defines in the fifth and sixth patch which were related to USB. - Sanchayan. Sanchayan Maity (5): ARM: vf610: Move DDR3 initialization to imx-common ARM: vf610: Add SoC and CPU type detection ARM: vf610: Initial integration for Colibri VF50/VF61 usb: host: Add ehci-vf USB driver for ARM Vybrid SoC's colibri_vf: Enable USB support for Colibri Vybrid Stefan Agner (2): ARM: vf610: Enable external 32KHz oscillator ARM: vf610: Enable caches arch/arm/Kconfig | 5 + arch/arm/cpu/armv7/vf610/generic.c | 45 ++- arch/arm/imx-common/Makefile | 3 + arch/arm/imx-common/ddrmc-vf610.c | 278 +++++++++++++++++++ arch/arm/include/asm/arch-vf610/crm_regs.h | 11 + arch/arm/include/asm/arch-vf610/ddrmc-vf610.h | 72 +++++ arch/arm/include/asm/arch-vf610/imx-regs.h | 36 ++- arch/arm/include/asm/imx-common/regs-usbphy.h | 26 ++ board/freescale/vf610twr/vf610twr.c | 295 +++++--------------- board/toradex/colibri_vf/Kconfig | 18 ++ board/toradex/colibri_vf/MAINTAINERS | 6 + board/toradex/colibri_vf/Makefile | 7 + board/toradex/colibri_vf/colibri_vf.c | 382 ++++++++++++++++++++++++++ board/toradex/colibri_vf/imximage.cfg | 17 ++ configs/colibri_vf_defconfig | 3 + drivers/usb/host/Makefile | 1 + drivers/usb/host/ehci-vf.c | 164 +++++++++++ include/configs/colibri_vf.h | 271 ++++++++++++++++++ 18 files changed, 1405 insertions(+), 235 deletions(-) create mode 100644 arch/arm/imx-common/ddrmc-vf610.c create mode 100644 arch/arm/include/asm/arch-vf610/ddrmc-vf610.h create mode 100644 arch/arm/include/asm/imx-common/regs-usbphy.h create mode 100644 board/toradex/colibri_vf/Kconfig create mode 100644 board/toradex/colibri_vf/MAINTAINERS create mode 100644 board/toradex/colibri_vf/Makefile create mode 100644 board/toradex/colibri_vf/colibri_vf.c create mode 100644 board/toradex/colibri_vf/imximage.cfg create mode 100644 configs/colibri_vf_defconfig create mode 100644 drivers/usb/host/ehci-vf.c create mode 100644 include/configs/colibri_vf.h -- 2.3.5 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
