On Thursday 15 January 2015 10:07:05 Pali Rohár wrote:
> Hello,
> 
> when starting U-Boot (from git master) on Nokia N900 it show
> lot of these lines on N900 screen:
> 
> Timed out in wait_for_event: status=0000
> Check if pads/pull-ups of bus 1 are properly configured
> Timed out in wait_for_event: status=0000
> Check if pads/pull-ups of bus 1 are properly configured
> ...
> i2c_read (addr phase): pads on bus 1 probably not configured
> (status=0x10)
> i2c_write: timeout writing last byte!
> 
> But booting linux kernel working without problem. What above
> warning messages means? They were not in U-Boot 2013.04
> version.

Ok, these warning/error lines are generated by this code:

        /* reset lp5523 led */
        i2c_set_bus_num(1);
        state = 0xff;
        i2c_write(0x32, 0x3d, 1, &state, 1);
        i2c_set_bus_num(0);

in function misc_init_r() in file board/nokia/rx51/rx51.c

Above code worked fine in U-Boot 2013.04 and now in U-Boot from 
git master it generates warnings/errors. Why?

-- 
Pali Rohár
pali.ro...@gmail.com

Attachment: signature.asc
Description: This is a digitally signed message part.

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to