Hi all, I've tried the first time booting a self compiled u-boot from git.marvell.com U-Boot can be downloaded and started with openocd quite well. Boot messages (version is dirty due to a comment in board file):
U-Boot 2009.06-rc2-02207-g14c575a-dirty (Jun 22 2009 - 13:40:45) Marvell-Sheevaplug SoC: Kirkwood 88F6281_A0 DRAM: 512 MB NAND: 512 MiB *** Warning - bad CRC or NAND, using default environment In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0 Hit any key to stop autoboot: 0 Marvell>> Environment is broken only with marvell git u-boot. Preflashed u-boot find environment is ok. Does sheevaplug u-boot from marvell git use other environment settings than preflashed u-boot? Marvell>> printenv bootcmd=${x_bootcmd_kernel}; setenv bootargs ${x_bootargs} ${x_bootargs_root}; bootm 0x6400000; bootdelay=3 baudrate=115200 x_bootargs=console=ttyS0,115200 mtdparts=orion_nand:512k(uboot),3...@1m(kernel),1...@4m(psm),1...@5m(rootfs) rw x_bootcmd_kernel=nand read 0x100000 0x6400000 0x300000 x_bootargs_root=root=/dev/mtdblock3 rw rootfstype=jffs2 stdin=serial stdout=serial stderr=serial ethaddr=00:50:43:e0:b9:d8 ethact=egiga0 ipaddr=192.168.2.75 (ipaddr is set after bootup with setenv ipaddr 192.168.2.75) If I now try to ping another machine in the same network: Marvell>> ping 192.168.2.251 Using egiga0 device This is all what happens - no response from board, CTRL-C doesn't work. Only a hard reset will get the board up again. Do I have to change something in the default board configuration to succesfullly use networking on the sheevaplug? u-boot is build with following commands: make ARCH=arm sheevaplug_config make I get no errors during build. My gcc version is: arm-none-linux-gnueabi-gcc (GCC) 4.2.0 20070413 (prerelease) Any help would be appreciated, Dieter _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot