> Add support for hdmi console. > > Signed-off-by: Nikita Kiryanov <nik...@compulab.co.il> > Cc: Stefano Babic <sba...@denx.de> > Cc: Igor Grinberg <grinb...@compulab.co.il> > --- > board/compulab/cm_fx6/cm_fx6.c | 51 ++++++++++++++++++++++++++++++++++++++++++ > include/configs/cm_fx6.h | 15 +++++++++++++ > 2 files changed, 66 insertions(+) [...] > +struct display_info_t const displays[] = { > + { > + .bus = -1, > + .addr = 0, > + .pixfmt = IPU_PIX_FMT_RGB24, > + .detect = detect_hdmi, > + .enable = cm_fx6_enable_hdmi, > + .mode = { > + .name = "HDMI", > + .refresh = 60, > + .xres = 1024, > + .yres = 768, > + .pixclock = 40385, > + .left_margin = 220, > + .right_margin = 40, > + .upper_margin = 21, > + .lower_margin = 7, > + .hsync_len = 60, > + .vsync_len = 10, > + .sync = FB_SYNC_EXT, > + .vmode = FB_VMODE_NONINTERLACED, > + } > + }, > +};
This is not VESA compliant. > +static void cm_fx6_setup_display(void) > +{ > + struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *) CCM_BASE_ADDR; > + int reg; > + > + enable_ipu_clock(); > + imx_setup_hdmi(); > + reg = __raw_readl(&mxc_ccm->CCGR3); > + reg |= MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK; > + writel(reg, &mxc_ccm->CCGR3); > +} This will not give the correct pixel clock for a framerate of 60 frames per second (as probably expected). Just as a warning: Due to the non-standard video timing most hdmi monitors will not work. For more compatible settings please have a look into the tbs2910 board code. Soeren _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot