Hi Stefan, On Mon, Dec 8, 2014 at 2:27 PM, Stefan Roese <s...@denx.de> wrote:
> Yes, its applied. I'm nearly on mainline right now. And it doesn't help. > Which makes sense if my current guess is correct, that the BootROM doesn't > load the SPL completely without this CCGR0 register setting in the DCD. On a mx6qsabresd booting via SPL: U-Boot SPL 2015.01-rc3-00158-ge3bf81b (Dec 18 2014 - 11:19:37) U-Boot 2015.01-rc3-00158-ge3bf81b (Dec 18 2014 - 11:19:37) CPU: Freescale i.MX6Q rev1.2 at 792 MHz CPU: Temperature 46 C Reset cause: POR Board: MX6-SabreSD I2C: ready DRAM: 1 GiB PMIC: PFUZE100 ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 *** Warning - bad CRC, using default environment No panel detected: default to Hannstar-XGA Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 => bmode sd3 resetting ... U-Boot SPL 2015.01-rc3-00158-ge3bf81b (Dec 18 2014 - 11:19:37) U-Boot 2015.01-rc3-00158-ge3bf81b (Dec 18 2014 - 11:19:37) CPU: Freescale i.MX6Q rev1.2 at 792 MHz CPU: Temperature 47 C Reset cause: WDOG Board: MX6-SabreSD I2C: ready DRAM: 1 GiB PMIC: PFUZE100 ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 *** Warning - bad CRC, using default environment No panel detected: default to Hannstar-XGA Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 => However if I move the SD card into SD2 slot, then it fails: => bmode sd2 resetting ... U-Boot SPL 2015.01-rc3-00158-ge3bf81b (Dec 18 2014 - 11:19:37) MMC: no card present spl: mmc init failed: err - -16 ### ERROR ### Please RESET the board ### The spl loaded, but it failed to load U-boot. Probably because SPL did not initialized SD2, so it seems things are working fine here. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
