On Mon, Dec 8, 2014 at 1:19 PM, Stefan Roese <s...@denx.de> wrote:
> Hi Fabio,
>
> On 08.12.2014 15:51, Fabio Estevam wrote:
>>>
>>> Could you test this on one of your board? If your board also fails to
>>> boot
>>> via the "bmode mmc0" command if the CCGR0 register value is missing?
>>
>>
>> I am currently out of the office without access to my mx6 board,
>
>
> I see. Perhaps you could do that once you are back in the office...
Sure, I will test it and will let you know how it goes.
In the meantime, I am wondering if the change below would allow your
board to boot:
--- a/arch/arm/cpu/armv7/mx6/soc.c
+++ b/arch/arm/cpu/armv7/mx6/soc.c
@@ -105,6 +105,10 @@ void init_aips(void)
#ifdef CONFIG_MX6SX
struct aipstz_regs *aips3;
#endif
+ struct mxc_ccm_reg *ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
+
+ /* Turn on AIPS1 and AIPS2 clocks */
+ setbits_le32(&ccm->CCGR0, 0xf);
aips1 = (struct aipstz_regs *)AIPS1_BASE_ADDR;
aips2 = (struct aipstz_regs *)AIPS2_BASE_ADDR;
Regards,
Fabio Estevam
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
