On 09/10/2014 07:59, Marek Vasut wrote:
> On Wednesday, October 08, 2014 at 05:35:44 PM, picmas...@mail.bg wrote:
>> Hi Sean,
> Hi all,
Hello
>
>> ----- Цитат от Sean Cross (x...@kosagi.com), на 08.10.2014 в 10:47 -----
>>
>>> On 08/10/2014 05:55, Nikolay Dimitrov wrote:
>>>> Hi Marek,
>>>>
>>>> I'm marking only the critical issues that are left unfixed from
>>>> previous conversations, to speed-up the process a little bit.
>>>> I'll send later patches for the non-critical issues to spare you the
>>>> extra work (and I'm sure my constructive criticism is already boring
>>>>
>>>> :D ).
>>>>
>>>> On 10/06/2014 07:02 PM, Marek Vasut wrote:
>>>>> +#define NOVENA_USB_HUB_RESET IMX_GPIO_NR(7, 12)
>>>> ...
>>>>
>>>>> +/*
>>>>> + * USB
>>>>> + */
>>>>> +#ifdef CONFIG_USB_EHCI_MX6
>>>>> +int board_ehci_hcd_init(int port)
>>>>> +{
>>>>> + /* Reset USB hub */
>>>>> + if (port == 1) {
>>>>> + gpio_set_value(NOVENA_USB_HUB_RESET, 0);
>>>>> + mdelay(2);
>>>>> + gpio_set_value(NOVENA_USB_HUB_RESET, 1);
>>>>> + }
>>>>> + return 0;
>>>>> +}
>>>>> +#endif
>>>> As we previously discussed, this pin definition conflicts with
>>>> NOVENA_PCIE_POWER_ON_GPIO (GPIO7_IO12 is connected to PCIE_PWRON), so
>>>> by asserting it, you'll turn-off the wrong sub-system.
>>>>
>>>> Currently the USB hub is reset only by system reset (RESETBMCU
>>>> asserted by the PMIC). I don't see how the CPU can selectively reset
>>>> the USB hub via a GPIO, so it would be better to remove the reset code.
>>>>
>>>> @Sean - can you please confirm/reject this finding?
>> @Sean: Do you have any comments on USB hub reset stuff? Should we ditch
>> entirely the reset code, or should we modify it somehow to work properly?
> OK, so it's just this USB that remains, right ?
This is correct. There is no GPIO-based way to reset the hub.
Sean
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
