On Wednesday, October 08, 2014 at 05:35:44 PM, picmas...@mail.bg wrote:
> Hi Sean,
Hi all,
> ----- Цитат от Sean Cross (x...@kosagi.com), на 08.10.2014 в 10:47 -----
>
> > On 08/10/2014 05:55, Nikolay Dimitrov wrote:
> >> Hi Marek,
> >>
> >> I'm marking only the critical issues that are left unfixed from
> >> previous conversations, to speed-up the process a little bit.
> >> I'll send later patches for the non-critical issues to spare you the
> >> extra work (and I'm sure my constructive criticism is already boring
> >>
> >> :D ).
> >>
> >> On 10/06/2014 07:02 PM, Marek Vasut wrote:
> >>> +#define NOVENA_USB_HUB_RESET IMX_GPIO_NR(7, 12)
> >>
> >> ...
> >>
> >>> +/*
> >>> + * USB
> >>> + */
> >>> +#ifdef CONFIG_USB_EHCI_MX6
> >>> +int board_ehci_hcd_init(int port)
> >>> +{
> >>> + /* Reset USB hub */
> >>> + if (port == 1) {
> >>> + gpio_set_value(NOVENA_USB_HUB_RESET, 0);
> >>> + mdelay(2);
> >>> + gpio_set_value(NOVENA_USB_HUB_RESET, 1);
> >>> + }
> >>> + return 0;
> >>> +}
> >>> +#endif
> >>
> >> As we previously discussed, this pin definition conflicts with
> >> NOVENA_PCIE_POWER_ON_GPIO (GPIO7_IO12 is connected to PCIE_PWRON), so
> >> by asserting it, you'll turn-off the wrong sub-system.
> >>
> >> Currently the USB hub is reset only by system reset (RESETBMCU
> >> asserted by the PMIC). I don't see how the CPU can selectively reset
> >> the USB hub via a GPIO, so it would be better to remove the reset code.
> >>
> >> @Sean - can you please confirm/reject this finding?
>
> @Sean: Do you have any comments on USB hub reset stuff? Should we ditch
> entirely the reset code, or should we modify it somehow to work properly?
OK, so it's just this USB that remains, right ?
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
