Hi Ashish, i had a problem booting vxworks in the past around interrupt vectors. Which version of vxworks you are using ? do you use a stripped image ? is the loadaddress the same within kernel configuration ?
best regards, hannes > From: Ashish Khetan <curieux.khe...@gmail.com> > To: u-boot@lists.denx.de > Date: 04.09.2014 14:13 > Subject: [U-Boot] VxWorks Booting using U-boot as Bootloader > Sent by: u-boot-boun...@lists.denx.de > > Hi, > I was trying to boot vxworks using u-boot bootloader for learning purpose > on MPC8640DHPCN board. Previously I successfully ported QNX os along with > linux on same board using u-boot. while booting using bootvx command its > not booting and stucking after showing the following message: > > tftp 01000000 vxWorks > Speed: 1000, full duplex > Using eTSEC1 device > TFTP from server 192.168.10.2; our IP address is 192.168.10.4 > Filename 'vxWorks'. > Load address: 0x1000000 > Loading: *################################################################# > ################################################################# > ################################# > 12.3 MiB/s > done > Bytes transferred = 2392432 (248170 hex) > BOSSv2.0=> bootvx 0010 1000000 > ## Ethernet MAC address not copied to NV RAM > ## Using bootline (@ 0x4200): root=/dev/nfs rw > nfsroot=192.168.10.2:/opt/eldk-5.3/powerpc/rootfs-basic > ip=192.168.10.4:192.168.10.2:192.168.10.1:255.255.255.0:Boss:eth0:off > panic=1 console=ttyS0,115200 > ## Starting vxWorks at 0x00100000 ... > > > please somebody provide me some link or any pointer to help me get more > understanding about booting multiple os using uboot. > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot