In order to support GPIO access in board_early_init_f() we must set up
driver model before this function is called. In any case, earlier is
better since driver model is (or will become) a key function for most
init.
Signed-off-by: Simon Glass <s...@chromium.org>
---
Changes in v7:
- Add new patch to init driver model before board_early_init_f()
Changes in v6: None
Changes in v5: None
Changes in v4: None
Changes in v3: None
Changes in v2: None
common/board_f.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/common/board_f.c b/common/board_f.c
index 4ece2b6..ea33ead 100644
--- a/common/board_f.c
+++ b/common/board_f.c
@@ -831,6 +831,8 @@ static init_fnc_t init_sequence_f[] = {
#ifdef CONFIG_OF_CONTROL
fdtdec_check_fdt,
#endif
+ initf_malloc,
+ initf_dm,
#if defined(CONFIG_BOARD_EARLY_INIT_F)
board_early_init_f,
#endif
@@ -866,8 +868,6 @@ static init_fnc_t init_sequence_f[] = {
sdram_adjust_866,
init_timebase,
#endif
- initf_malloc,
- initf_dm,
init_baud_rate, /* initialze baudrate settings */
serial_init, /* serial communications setup */
console_init_f, /* stage 1 init of console */
--
2.1.0.rc2.206.gedb03e5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
