The capacity and lba for an MMC device with part_num 0 reflects the whole device. When mmc_switch_part() successfully switches to a partition, the capacity is changed to that partition. As partition 0 does not physically exist, attempts to switch back to the whole device will indicate an error, but the capacity setting for the whole device must still be restored to match the partition.
Signed-off-by: Peter A. Bigot <p...@pabigot.com> --- drivers/mmc/mmc.c | 11 ++++++++--- 1 file changed, 8 insertions(+), 3 deletions(-) diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c index a26f3ce..fa04a3f 100644 --- a/drivers/mmc/mmc.c +++ b/drivers/mmc/mmc.c @@ -594,10 +594,15 @@ int mmc_switch_part(int dev_num, unsigned int part_num) ret = mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_PART_CONF, (mmc->part_config & ~PART_ACCESS_MASK) | (part_num & PART_ACCESS_MASK)); - if (ret) - return ret; - return mmc_set_capacity(mmc, part_num); + /* + * Set the capacity if the switch succeeded or was intended + * to return to representing the raw device. + */ + if ((ret == 0) || ((ret == -ENODEV) && (part_num == 0))) + ret = mmc_set_capacity(mmc, part_num); + + return ret; } int mmc_getcd(struct mmc *mmc) -- 1.8.5.5 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot