Hi Nikita, On 11 August 2014 08:39, Nikita Kiryanov <nik...@compulab.co.il> wrote: > > > On 11/08/14 17:15, Simon Glass wrote: >> >> Hi, >> >> On 11 August 2014 02:20, Nikita Kiryanov <nik...@compulab.co.il> wrote: >>> >>> Hi Simon, >>> >>> >>> On 11/08/14 03:11, Simon Glass wrote: >>>> >>>> >>>> Hi Nikita, >>>> >>>> On 10 August 2014 11:12, Nikita Kiryanov <nik...@compulab.co.il> wrote: >>>>> >>>>> >>>>> This partial V2 completes the previous partial V2. It contains some >>>>> final >>>>> preparational steps, and the introduction of cm-fx6 board. >>>>> >>>>> Changes in V2: >>>>> - Update commit message of "arm: mx6: ddr: configure MMDC for >>>>> slow_pd" >>>>> - Remove unnecessary line removal from >>>>> arch/arm/cpu/armv7/mx6/ddr.c >>>>> - Move probe_mmdc_config() code straight to dram_init() >>>>> - Use imx6_spl.h >>>>> - Use imx_ddr_size() >>>>> NOTE: the correction of this patch now depends on >>>>> https://patchwork.ozlabs.org/patch/376095/ >>>> >>>> >>>> >>>> Does this series support the dual core Utilite machine? >>> >>> >>> >>> It does support dual core, but not the Utilite boot sequence. Right now >>> you can only boot from MMC because SPL has no fallback functionality and >>> Utilite always tries MMC first. I'll be sending patches for that after >>> this series is accepted. >>> >>> >>>> If so I'm not sure how to enable dual core instead of quad core - any >>>> ideas please? >>> >>> >>> >>> You don't need to do anything to run this on dual core. ...or am I >>> misunderstanding your question? >> >> >> I'm not sure. It was failing to boot from SD and I thought that might >> be the problems, since I see quite a few CPU-related configs in the >> board config file. Is there a canonical description of how to making a >> boot image and put it on SD? Perhaps I was doing that incorrectly. > > > You can use the article from the Compulab wiki: > > http://compulab.co.il/workspace/mediawiki/index.php5/CM-FX6:_U-Boot:_Creating_a_bootable_SD_card > > This article assumes that both SPL and U-Boot reside on a single > binary at the right offsets. The following article describes the > steps for creating this joined image: > > http://compulab.co.il/workspace/mediawiki/index.php5/CM-FX6:_U-Boot:_Building_Images#Building_the_firmware_images
Thanks, that works. Somehow I didn't have the two sets of instructions in one place. I have a few comments on the patches which I will send separately. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
