On Thu, May 29, 2014 at 12:02 AM, Stefano Babic <sba...@denx.de> wrote: > Hi Tim, > > I cannot build with this version. A setup for a couple of pins is not > yet replaces. > > In fact, I have: > > /* Enable Backlight */ > imx_iomux_v3_setup_pad(MX6_PAD_SD1_CMD__GPIO1_IO18 | > > and it should be: > > SETUP_IOMUX_PAD(PAD_SD1_CMD__GPIO1_IO18 | > > The same some lines later: > > /* Backlight CABEN on LVDS connector */ > - imx_iomux_v3_setup_pad(MX6_PAD_SD2_CLK__GPIO1_IO10 | > + SETUP_IOMUX_PAD(PAD_SD2_CLK__GPIO1_IO10 | > > > Can you check and fix it ? Thanks ! > > Regarding your patchset: I had no remarkable comments and, as I have not > seen any comments from other developers, your patchset is ready to be > merged. I am also waiting for Masahiro's patch to be applied. > > Best regards, > Stefano Babic >
Stefano, Those should be patched from patch 10. However, I can't seem to get patch 9 to apply cleanly from current u-boot-imx/master so perhaps I should just rebase the whole series and post again? Tim _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot