Hi Tim,
I cannot build with this version. A setup for a couple of pins is not
yet replaces.
In fact, I have:
/* Enable Backlight */
imx_iomux_v3_setup_pad(MX6_PAD_SD1_CMD__GPIO1_IO18 |
and it should be:
SETUP_IOMUX_PAD(PAD_SD1_CMD__GPIO1_IO18 |
The same some lines later:
/* Backlight CABEN on LVDS connector */
- imx_iomux_v3_setup_pad(MX6_PAD_SD2_CLK__GPIO1_IO10 |
+ SETUP_IOMUX_PAD(PAD_SD2_CLK__GPIO1_IO10 |
Can you check and fix it ? Thanks !
Regarding your patchset: I had no remarkable comments and, as I have not
seen any comments from other developers, your patchset is ready to be
merged. I am also waiting for Masahiro's patch to be applied.
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
