On Wednesday, May 14, 2014 at 07:26:36 PM, Stephen Warren wrote:
> On 05/01/2014 10:47 PM, Marek Vasut wrote:
> > On Thursday, May 01, 2014 at 06:56:24 PM, Stephen Warren wrote:
> >> On 05/01/2014 04:49 AM, Marek Vasut wrote:
> >>> On Wednesday, April 30, 2014 at 11:09:55 PM, Stephen Warren wrote:
> >>>> From: Stephen Warren <swar...@nvidia.com>
> >>>>
> >>>> The TRM for Tegra30 and later all state that USBMODE_CM_HC must be set
> >>>> before writing to hostpc1_devlc to select which PHY to use for a USB
> >>>> controller. However, neither init_{utmi,ulpi}_usb_controller() do this
> >>>> today, so the register writes they perform for PHY selection do not
> >>>> work.
> >>>>
> >>>> For the UTMI case, this was hacked around in commit 7e44d9320ed4 "ARM:
> >>>> Tegra: USB: EHCI: Add support for Tegra30/Tegra114" by adding code to
> >>>> ehci_hcd_init() which sets USBMODE_CM_HC and duplicates the PHY
> >>>> selection register write. This code doesn't cover the ULPI case, so I
> >>>> wouldn't be surprised if ULPI doesn't work with the current code,
> >>>> unless the ordering requirement only ends up being an issue in HW for
> >>>> UTMI not ULPI.
> >>>>
> >>>> This patch fixes init_{utmi,ulpi}_usb_controller() to correctly set
> >>>> USBMODE_CM_HC before selecting the PHY. Now that this works, we can
> >>>> remove the duplicate UTMI-specific code in ehci_hcd_init(), thus
> >>>> simplifying that function.
> >>>
> >>> This doesn't apply on u-boot-usb/master , so I cannot pick this, sorry
> >>> .
Applied, thanks.
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
