Hi Fabio, On 04/11/2014 01:43 PM, Fabio Estevam wrote:
From: Fabio Estevam <fabio.este...@freescale.com>ECSPI chipselect (MX6_PAD_EIM_D19__GPIO3_IO19) is used with GPIO functionality, so it does not make sense to set its pad as SPI pin. Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> --- Eric, This is untested. board/boundary/nitrogen6x/nitrogen6x.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c index d9c05b0..f2492e4 100644 --- a/board/boundary/nitrogen6x/nitrogen6x.c +++ b/board/boundary/nitrogen6x/nitrogen6x.c @@ -331,7 +331,7 @@ int board_mmc_init(bd_t *bis) #ifdef CONFIG_MXC_SPI iomux_v3_cfg_t const ecspi1_pads[] = { /* SS1 */ - MX6_PAD_EIM_D19__GPIO3_IO19 | MUX_PAD_CTRL(SPI_PAD_CTRL), + MX6_PAD_EIM_D19__GPIO3_IO19 | MUX_PAD_CTRL(NO_PAD_CTRL), MX6_PAD_EIM_D17__ECSPI1_MISO | MUX_PAD_CTRL(SPI_PAD_CTRL), MX6_PAD_EIM_D18__ECSPI1_MOSI | MUX_PAD_CTRL(SPI_PAD_CTRL), MX6_PAD_EIM_D16__ECSPI1_SCLK | MUX_PAD_CTRL(SPI_PAD_CTRL),
Tested-by: Eric Nelson <eric.nel...@boundarydevices.com> Acked-by: Eric Nelson <eric.nel...@boundarydevices.com> _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
