On 02.04.2014 05:33, nitin.g...@freescale.com wrote:
From: Nitin Garg <nitin.g...@freescale.com>
A short loop including a DMB instruction might cause a denial of
service on another processor which executes a CP15 broadcast operation.
Exists on r1, r2, r3, r4 revisions.
Signed-off-by: Nitin Garg <nitin.g...@freescale.com>
---
README | 1 +
arch/arm/cpu/armv7/start.S | 5 +++++
2 files changed, 6 insertions(+), 0 deletions(-)
diff --git a/README b/README
index 7cb7c4f..a496c65 100644
--- a/README
+++ b/README
@@ -566,6 +566,7 @@ The following options need to be configured:
CONFIG_ARM_ERRATA_742230
CONFIG_ARM_ERRATA_743622
CONFIG_ARM_ERRATA_751472
+ CONFIG_ARM_ERRATA_794072
If set, the workarounds for these ARM errata are applied early
during U-Boot startup. Note that these options force the
diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S
index ac1e55a..b87a378 100644
--- a/arch/arm/cpu/armv7/start.S
+++ b/arch/arm/cpu/armv7/start.S
@@ -222,6 +222,11 @@ ENTRY(cpu_init_cp15)
orr r0, r0, #1 << 11 @ set bit #11
mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register
#endif
+#ifdef CONFIG_ARM_ERRATA_794072
+ mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register
+ orr r0, r0, #1 << 4 @ set bit #4
+ mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register
+#endif
Where is the difference between the errata code for above new
CONFIG_ARM_ERRATA_794072 and the existing
#ifdef CONFIG_ARM_ERRATA_742230
mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register
orr r0, r0, #1 << 4 @ set bit #4
mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register
#endif
?
Maybe we should just do a
#if (defined(CONFIG_ARM_ERRATA_794072) || defined(CONFIG_ARM_ERRATA_742230))
?
Best regards
Dirk
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
