On Sat, Jan 11, 2014 at 3:45 AM, Gupta, Pekon <pe...@ti.com> wrote: > > >From: abraham.varric...@vvdntech.com > >Hello, > > > >Thanks to the help I obtained on this mailing list, I've been able to > >customize u-boot (2013.10 release) to work on a custom omap4460 board. > >Schematically, it's similar to the pandaboard, but uses the twl6032 > >pmic and has a NAND memory from micron present. > > > > > >The problem I'm facing is that I can't seem to boot directly from the > >nand memory chip. We've set the boot configuration pins to start with > >NAND boot, but it doesn't seem to work. On probing the CS and > >nand-busy lines we can see some activity happening, but don't > >understand what it means. > > > > > >Any suggestions on how I could debug this? > > > If this NAND has bus-width = 16, then you need to tweak the > board file with following changes. > Below code is for AM335x platforms, you need similar for omap4 platforms
No, the NAND memory I'm using has a bus-width of 8. -Abraham V. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
