From: Fabio Estevam <fabio.este...@freescale.com>
There is no need to print an error message when cpu_eth_init() fails because
net/eth.c already prints it.
In order to simplify the code, just return the value from cpu_eth_init(bis)
directly.
Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
---
board/freescale/mx6qsabreauto/mx6qsabreauto.c | 8 +-------
1 file changed, 1 insertion(+), 7 deletions(-)
diff --git a/board/freescale/mx6qsabreauto/mx6qsabreauto.c
b/board/freescale/mx6qsabreauto/mx6qsabreauto.c
index fc75eae..928dadf 100644
--- a/board/freescale/mx6qsabreauto/mx6qsabreauto.c
+++ b/board/freescale/mx6qsabreauto/mx6qsabreauto.c
@@ -192,15 +192,9 @@ int board_phy_config(struct phy_device *phydev)
int board_eth_init(bd_t *bis)
{
- int ret;
-
setup_iomux_enet();
- ret = cpu_eth_init(bis);
- if (ret)
- printf("FEC MXC: %s:failed\n", __func__);
-
- return ret;
+ return cpu_eth_init(bis);
}
#define BOARD_REV_B 0x200
--
1.8.1.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
