On Thursday 19 December 2013 10:30 PM, Tom Rini wrote: > On Wed, Dec 18, 2013 at 03:07:47PM -0500, Tom Rini wrote: >> On Tue, Dec 10, 2013 at 03:02:10PM +0530, Lokesh Vutla wrote: >> >>> This Patch series updates support for AM4372 EPOS and GP EVM boards. >>> AM4372 is a low cost Cortex-A9 based application processor targeted at >>> existing >>> ARM9/ARM11 base of customers that need more processing capabilities. >>> Currently there are two boards with AM4372 SoC: EPOS and GP EVM. >>> Except for few differences like oscillator clock and SDRAM both EPOS and GP >>> EVM >>> boards are similar. >>> EPOS EVM: >>> OSC clk : 25MHz >>> DDR : LPDDR2 @ 266MHz (MT42L256M32D2LG-25 WT:A) >>> GP EVM: >>> OSC clk : 24MHz >>> DDR : DDR3 @ 400MHz(MT41K512M8RH) >>> >>> This patch series is applied on top of Mainline U-Boot Tree and two >>> patches mentioned below: >>> git://git.denx.de/u-boot.git master >>> http://patchwork.ozlabs.org/patch/288175/ >>> >>> Testing: >>> -> Boot tested on AM4372 EPOS and GP EVMs, Beaglebone Black. >>> -> verified MAKEALL -s am33xx. >>> -> Ran checkpatch on all patches. >>> >>> Changes Since V2: >>> -> Updating the base offsets only for AM43xx >>> -> Populated DPLLs data for all OPPs and SYS CLK inputs and the correct >>> values >>> to be read from eFuse. >>> -> Seperated out ioregs changes into a new patch. >>> >>> Changes Since V1: >>> As per Vaibhav's and Tom's Comments: >>> -> Updated the mux data not to use DSPULLUDEN. >>> -> Reused the emif4d file for configuring emif4d5 registers. >>> -> Updated the code with comments. >>> -> Rebased on top of Current U-Boot mainline. >>> >>> Lokesh Vutla (12): >>> ARM: AM43xx: Update the base addresses of modules >>> ARM: AM43xx: Adapt to ti_armv7_common.h config file >>> ARM: AM43xx: Add L2 Support >>> ARM: AM43xx: Add extra ENV settings >>> ARM: AM43xx: Select clk source for Timer2 >>> ARM: AM43xx: Update Current Booting devices list >>> ARM: AM43xx: mux: Update mux data >>> ARM: AM43xx: clocks: Update DPLL details >>> ARM: AM33xx+: Update ioregs to pass different values >>> ARM: AM43xx: EPOS_EVM: Add support for LPDDR2 >>> ARM: AM43xx: GP_EVM: Add support for DDR3 >>> ARM: AM43xx: Add Maintainer >>> >>> Sekhar Nori (2): >>> ARM: AM43XX: board: add support for reading onboard EEPROM >>> ARM: AM43XX: Add CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG support >>> >>> arch/arm/cpu/armv7/am33xx/clock.c | 12 +- >>> arch/arm/cpu/armv7/am33xx/clock_am33xx.c | 15 + >>> arch/arm/cpu/armv7/am33xx/clock_am43xx.c | 12 +- >>> arch/arm/cpu/armv7/am33xx/ddr.c | 146 +++++++- >>> arch/arm/cpu/armv7/am33xx/emif4.c | 25 +- >>> arch/arm/cpu/armv7/omap-common/emif-common.c | 14 - >>> arch/arm/include/asm/arch-am33xx/clock.h | 7 +- >>> arch/arm/include/asm/arch-am33xx/clocks_am33xx.h | 3 + >>> arch/arm/include/asm/arch-am33xx/cpu.h | 24 +- >>> arch/arm/include/asm/arch-am33xx/ddr_defs.h | 41 ++- >>> arch/arm/include/asm/arch-am33xx/gpio.h | 12 + >>> arch/arm/include/asm/arch-am33xx/hardware.h | 7 - >>> arch/arm/include/asm/arch-am33xx/hardware_am33xx.h | 2 + >>> arch/arm/include/asm/arch-am33xx/hardware_am43xx.h | 16 + >>> arch/arm/include/asm/arch-am33xx/mux_am43xx.h | 45 +++ >>> arch/arm/include/asm/arch-am33xx/omap.h | 4 +- >>> arch/arm/include/asm/arch-am33xx/spl.h | 13 +- >>> arch/arm/include/asm/emif.h | 26 ++ >>> board/isee/igep0033/board.c | 10 +- >>> board/phytec/pcm051/board.c | 12 +- >>> board/siemens/dxr2/board.c | 10 +- >>> board/siemens/pxm2/board.c | 10 +- >>> board/siemens/rut/board.c | 10 +- >>> board/ti/am335x/board.c | 40 ++- >>> board/ti/am43xx/board.c | 355 >>> +++++++++++++++++++- >>> board/ti/am43xx/board.h | 36 ++ >>> board/ti/am43xx/mux.c | 35 +- >>> board/ti/ti814x/evm.c | 4 +- >>> board/ti/ti816x/evm.c | 12 +- >>> boards.cfg | 2 +- >>> include/configs/am43xx_evm.h | 204 +++++------ >>> 31 files changed, 983 insertions(+), 181 deletions(-) >> >> Applied to u-boot-ti/master, thanks! > > Note that I've had to update this patch series to fix cm_t335 support > and cover pcm051_rev3. Also the dxr2 conversion wasn't quite right (it > should have been populating based on settings.ddr3.ioctrl_val) so I > fixed that up. Oops..!! Sorry somehow overlooked these. Thanks a lot Tom.
Regards, Lokesh > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
