2013/12/19 Marek Vasut <ma...@denx.de>:
> On Thursday, December 19, 2013 at 01:54:56 AM, Kuo-Jung Su wrote:
>> 2013/12/18 Marek Vasut <ma...@denx.de>:
>> > On Wednesday, December 18, 2013 at 08:24:48 AM, Kuo-Jung Su wrote:
>> >> From: Kuo-Jung Su <dant...@faraday-tech.com>
>> >>
>> >> Since hardware revision 1.11.0, the following interrupt status registers
>> >
>> >> are now write-1-clear (w1c):
>> > What did they look like before ?
>>
>> They were r/w registers. i.e., software must write a zero to clear the
>> status. I'll add the comment in next version.
>
> OK.
>
>> >> 1. Interrupt Source Group 0 Register (0x144) (EP0 Abort: BIT5)
>> >> 2. Interrupt Source Group 2 Register (0x14C) (All bits)
>> >>
>> >> Signed-off-by: Kuo-Jung Su <dant...@faraday-tech.com>
>> >> CC: Marek Vasut <ma...@denx.de>
>> >> ---
>> >>
>> >> drivers/usb/gadget/fotg210.c | 10 ++++++++--
>> >> 1 file changed, 8 insertions(+), 2 deletions(-)
>> >>
>> >> diff --git a/drivers/usb/gadget/fotg210.c b/drivers/usb/gadget/fotg210.c
>> >> index 6e19db1..e3a61cc 100644
>> >> --- a/drivers/usb/gadget/fotg210.c
>> >> +++ b/drivers/usb/gadget/fotg210.c
>> >> @@ -847,8 +847,11 @@ int usb_gadget_handle_interrupts(void)
>> >>
>> >> /* CX interrupts */
>> >> if (gisr & GISR_GRP0) {
>> >>
>> >> st = readl(®s->gisr0);
>> >>
>> >> +#ifdef CONFIG_USB_GADGET_FOTG210_ISRW1C
>> >
>> > Can we not get rid of this ifdef somehow please ? Like detect the
>> > revision on- the-fly and handle the bit accordingly or such ?
>>
>> Unfortunately there is no revision id register in this hardware, so I
>> have to do it manually.
>
> So what would happen if you write 1, then write 0 into them ? ;-) Won't that
> handle both cases? Writing one will make sure the clean them on new hardware,
> writing zero afterwards will clean them on old hardware.
>
Good idea! I think it should work just fine.
I'll make sure if does work, and then prepare for the new patch.
> Best regards,
> Marek Vasut
--
Best wishes,
Kuo-Jung Su
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
