On 12/06/2013 12:53 AM, Shengzhou Liu wrote:
> - optimize ddr parameters for whole frequency range from 1500MT/s to 2140MT/s.
> - remove unused patameters: 'cpo', 'wrdata delay', '2T', which is unrelated
> to DDR3/3L on t2080qds.
> - remove unused rdimm code(only udimm is supported on t2080qds).
>
> Signed-off-by: Shengzhou Liu <shengzhou....@freescale.com>
> ---
> Against master branch of git://git.denx.de/u-boot-mpc85xx.git
>
> board/freescale/t2080qds/ddr.c | 20 ++-----------
> board/freescale/t2080qds/ddr.h | 64
> +++++++++---------------------------------
> 2 files changed, 17 insertions(+), 67 deletions(-)
>
> diff --git a/board/freescale/t2080qds/ddr.c b/board/freescale/t2080qds/ddr.c
> index 5db5d21..bc366ae 100644
> --- a/board/freescale/t2080qds/ddr.c
> +++ b/board/freescale/t2080qds/ddr.c
> @@ -24,24 +24,17 @@ void fsl_ddr_board_options(memctl_options_t *popts,
> const struct board_specific_parameters *pbsp, *pbsp_highest = NULL;
> ulong ddr_freq;
>
> - if (ctrl_num > 2) {
> + if (ctrl_num > 1) {
> printf("Not supported controller number %d\n", ctrl_num);
> return;
> }
> if (!pdimm->n_ranks)
> return;
>
> - /*
> - * we use identical timing for all slots. If needed, change the code
> - * to pbsp = rdimms[ctrl_num] or pbsp = udimms[ctrl_num];
> - */
> - if (popts->registered_dimm_en)
> - pbsp = rdimms[0];
> - else
> - pbsp = udimms[0];
> + pbsp = udimms[0];
>
This is not right. You should throw out an error if RDIMM is not
supported. But why isn't it supported? T2080 SoC can support RDIMM.
York
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
