Hi Andre, On 4 December 2013 17:09, Andre Przywara <andre.przyw...@linaro.org> wrote: > Hi, > > I cannot get upstream u-boot to run on an Arndale board. Everything works > when I use the Linaro branch. But this tree is old and carries a whole > different set of patches for Arndale. > Is the Arndale upstream support supposed to work? If yes, is there a > different recipe for populating the uSD card? > > What works is the following: > $ git checkout linaro > $ make arndale5250_config && make -j arndale5250 > $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1 > $ dd if=spl/smdk5250-spl.bin of=/dev/sdb seek=17 > $ dd if=u-boot.bin of=/dev/sdb seek=49 > > Transferring this to upstream I get the following: > $ git checkout master > $ make arndale_config && make -j arndale > $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1 > $ dd if=spl/arndale-spl.bin of=/dev/sdb seek=17 > $ dd if=u-boot.bin of=/dev/sdb seek=49 dd if=u-boot-dtb.bin of=/dev/sdb seek=49 > > However while the Linaro based build works fine, I don't get any serial > output on the upstream build. > > Can someone give any hints? > > Thanks, > Andre.
-- with warm regards, Chander Kashyap _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot