Hi Michal,
On Thu, 22 Aug 2013 14:52:02 +0200, Michal Simek
<michal.si...@xilinx.com> wrote:
> Zynq lowlevel_init() was implemented in C but stack
> pointer is setup after function call in _main().
> Move architecture setup to arch_cpu_init() which is call
> as the first function in board_init_f() which
> already have correct stack pointer.
>
> Reported-by: Sven Schwermer <sven.schwer...@tuhh.de>
> Signed-off-by: Michal Simek <michal.si...@xilinx.com>
> ---
> I can't see any problem to call zynq setup a little
> bit later. There is already expectation that u-boot
> runs from DDR.
> Moving lowlevel_init from C to ASM is possible but
> I will have to introduce new macros with hardcoded
> values. Using structures is much nicer.
>
> ---
> arch/arm/cpu/armv7/zynq/cpu.c | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/arch/arm/cpu/armv7/zynq/cpu.c b/arch/arm/cpu/armv7/zynq/cpu.c
> index 4367d1a..8846f30 100644
> --- a/arch/arm/cpu/armv7/zynq/cpu.c
> +++ b/arch/arm/cpu/armv7/zynq/cpu.c
> @@ -11,6 +11,10 @@
>
> void lowlevel_init(void)
> {
> +}
> +
> +int arch_cpu_init(void)
> +{
> zynq_slcr_unlock();
> /* remap DDR to zero, FILTERSTART */
> writel(0, &scu_base->filter_start);
> @@ -31,6 +35,8 @@ void lowlevel_init(void)
> writel(0xC, &slcr_base->ddr_urgent);
>
> zynq_slcr_lock();
> +
> + return 0;
> }
>
> void reset_cpu(ulong addr)
> --
> 1.8.2.3
>
>
Applied to u-boot-arm/master, thanks!
Amicalement,
--
Albert.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
