Thanks for the feedback, Heiko! I will take a look at the new framework...
Michael Burr // Software Engineer II Logic PD T // 612.436.7273 NOTICE: Important disclaimers and limitations apply to this email. Please see this web page for our disclaimers and limitations: http://logicpd.com/email-disclaimer/ -----Original Message----- From: Heiko Schocher [mailto:h...@denx.de] Sent: Wednesday, September 18, 2013 2:14 AM To: Michael Burr Cc: u-boot@lists.denx.de Subject: Re: [U-Boot] [PATCH] i2c:zynq: I2C multi-bus support on Zynq Hello Michael, a "How to send patches", Jagan Teki responded to you, so I only comment your patch ... Am 17.09.2013 19:29, schrieb Michael Burr: > Zynq PS has two I2C bus masters (called 'I2C0' and 'I2C1'): >> Implement 'i2c_set_bus_num' routine to select from these. > Support I2C devices which do not use internal addresses: >> Handle case of 'alen == 0' in 'i2c_read', 'i2c_write'. > This supports PCA9548 bus multiplexer on Xilinx ZC702 board. > Tested cases of 'alen == 0' and 'alen == 1' on this board. > Further minor corrections: >> Write 'address' register before 'data' register. >> Write 'transfer_size' register before 'address' register. > > Signed-off-by: Michael Burr<michael.b...@logicpd.com> > Cc: Albert Aribaud<albert.u.b...@aribaud.net> > Cc: Heiko Schocher<h...@denx.de> > Cc: Michal Simek<mon...@monstr.eu> > --- > drivers/i2c/zynq_i2c.c | 87 > ++++++++++++++++++++++++++++++------------------ > 1 file changed, 55 insertions(+), 32 deletions(-) Thanks for your work! But please use the new i2c multibus/multiadapter framework for adding multibus support for this driver. Currently 4 i2c drivers are ported to this new framework, see: http://git.denx.de/?p=u-boot.git;a=commitdiff;h=880540decfb855e96bc14ac84ac7784669e4b382 http://git.denx.de/?p=u-boot.git;a=commitdiff;h=1f2ba722ac06393d6abe6d4734824d3b98ea9108 http://git.denx.de/?p=u-boot.git;a=commitdiff;h=00f792e0df9ae942427e44595a0f4379582accee http://git.denx.de/?p=u-boot.git;a=commitdiff;h=ea818dbbcd59300b56014ac2d67798a54994eb9b You can use them as a base for your work bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot